EasyManuals Logo

EMC VNX VG2 User Manual

EMC VNX VG2
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #272 background imageLoading...
Page #272 background image
EMC VNX VG2/VG8 Gateway Configuration Setup Guide
272
Setup Worksheets
EMC CONFIDENTIAL
Site preparation worksheet
Before beginning the installation of a VG2/VG8 system, verify that the following site
preparation steps are complete. “Step 2: Confirm site preparation” on page 47
provides details:
All components on site
Four power circuits with correct outlets available at cabinet location
Network cables run to cabinet location
Boot array installed and initial configuration complete:
Boot array has at least four unused disks available
Symmetrix boot array (DMX, VMAX, or VMAXe) has been configured with
the required hypervolumes to support the system
Configuration planning complete and all required customer information collected
and recorded, including:
IP addresses, hostnames, netmasks, and default gateway addresses for Control
Station and blades
Usernames and passwords for Fibre Channel (FC) or Fibre Channel over
Ethernet (FCoE) switch and VNX array management programs
CCA complete and approved
CDs for correct EMC NAS software revision available

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EMC VNX VG2 and is the answer not in the manual?

EMC VNX VG2 Specifications

General IconGeneral
BrandEMC
ModelVNX VG2
CategoryGateway
LanguageEnglish

Related product manuals