EMC VNX VG2 - Express Install for File OE Release 7.1 or Higher

Express Install for File OE Release 7.1 or higher
217
NAS Install Options
EMC CONFIDENTIAL
Express Install for File OE Release 7.1 or higher
This version of the Express Install eliminates several user prompts by auto-detecting
the needed values. To install the EMC NAS software on the CS, follow these steps:
Note: Use the Ta b key to navigate between fields; press Enter to select values.
1. Insert the EMCNAS installation media into the Control Station, press the power
button off for 5 seconds, then press the button on to reboot the Control Station.
The Control Station displays its boot messages followed by the prompt shown in
Figure 134 on page 217.
2. Type gateway, and then press Enter.
Note: You have one minute to type an installation command; otherwise the system will
look for an existing installation.
After you type the command, the system copies the contents of the media to the
CS, ejects the media, and then restarts the CS.
Figure 134 Install software prompt
3. If prompted to confirm the installation, type yes to continue.
4. If the system displays the prompt shown in Figure 135, tab to Yes, and then press
Enter.