EMC CONFIDENTIAL
Appendix E, “NAS Install Options”
This appendix explains how to use the kickstart installation procedure. Instead of
entering configuration information interactively during a software installation, you
enter the values into a file in advance. The software installation can then run without
stopping to prompt you for information.
Appendix F, “Manually Zone Switches and Configure System LUNs”
This appendix explains how to manually configure the system’s LUNs, including the
RAID group and storage group on a VNX boot array. It also explains how to
manually zone the Fibre Channel switches used to connect the VNX gateway to its
boot array.
Appendix G, “Cable Connections from Fibre Channel Switch to Storage Array”
This appendix describes the cable connections from the Fibre Channel switch to the
legacy CLARiiON arrays.
Appendix H, “Setup Worksheets”
This appendix provides an easy way to collect and record configuration settings
before starting the installation.
Appendix I, “Navisphere Manager procedures”
This appendix provides Navisphere Manager procedures that you use when
performing tasks on backend storage arrays that have FLARE versions prior to R30.
To Next Page
Loading...
Need help?
General
