1019567 REV. 03 99
Figure 5.22 Main Support Assembly, Side View
WARNING General Warning
Before servicing the welder, make sure to do the following:
1. Turn off the welder and unplug main power.
2. Turn air pressure to zero and disconnect your main air line connection.
Failure to do this leaves the welder under potentially dangerous air
pressure.
3. Wait approximately 2 minutes after unplugging the welder before touching
internal electrical components.
CAUTION General Warning
Take extra caution not to leave any loose objects (such as screws,
bolts, nuts, and so forth) in the welder. If you drop an object into the
welder, retrieve the object immediately.
To Next Page
Loading...
