Emerson 2000IW - Connecting and Disconnecting Air Lines; Figure 5.1 Connecting and Disconnecting Air Lines

66 1019567 REV. 03
5.2 Connecting and Disconnecting Air Lines
Figure 5.1 Connecting and Disconnecting Air Lines shows how to connect and disconnect
the air line connection on the welder.
Figure 5.1 Connecting and Disconnecting Air Lines
When replacing air lines, use 1/4 in. OD tubing. To avoid air leaks, make sure to cut the
tubing ends squarely and cleanly.
WARNING General Warning
Before servicing the welder, make sure to do the following:
1. Turn off the welder and unplug main power.
2. Turn air pressure to zero and disconnect your main air line connection.
Failure to do this leaves the welder under potentially dangerous air
pressure.
3. Wait approximately 2 minutes after unplugging the welder before touching
internal electrical components.
CAUTION General Warning
After connecting an air line, tug the line to make sure that it locks
securely into the fitting.
CONNECT
DISCONNECT