42 1019567 REV. 03
These signals can be interfaced with a customer supplied device to monitor system status
and trigger some action when the signals become active or inactive.
Pins 5 and 6 provide a +24V DC source (100mA maximum). Pins 21, 22, and 23 provide
+24V DC return (common). The remaining pins are unused.
Figure 3.6 IW/IW+ Input Output Signals
Note 1: You will note that the following pins are not connected: Pins 1, 2, 3, 4, 7, 8, 11, 12, 14,
15, 16, 17, and 24.
Note 2: Typical Circuitry for Pins 18, 19, and 20.
CAUTION General Warning
Ensure all unused wires are properly isolated. Failure to do so may
result in Power Supply Module or system failure.
To Next Page
Loading...
