Emerson 2000IW - Figure 5.7 Circuit Breaker, on off Switch

76 1019567 REV. 03
5.4.3 Circuit Breaker, On Off Switch
5.4.3.1 Remove and Replace Circuit Breaker, On Off Switch
Figure 5.7 Circuit Breaker, On Off Switch
1. Turn off the welder and unplug main power.
2. Turn air pressure to zero, then disconnect main air supply.
WARNING General Warning
Before servicing the welder, make sure to do the following:
1. Turn off the welder and unplug main power.
2. Turn air pressure to zero and disconnect your main air line connection.
Failure to do this leaves the welder under potentially dangerous air
pressure.
3. Wait approximately 2 minutes after unplugging the welder before touching
internal electrical components.
WARNING General Warning
Turn air pressure to zero and disconnect the main air supply. Failure
to do this leave the welder under potentially dangerous air pressure.