50 1019567 REV. 03
4.1 General Troubleshooting Procedures
If you have a problem operating your welder, take the following steps:
1. If error messages appear, refer to 4.3 Alarms which provides definitions and solutions for each
alarm.
2. Refer to the troubleshooting charts in
4.2 Troubleshooting Charts. These charts list common
welder problems and possible solutions to these problems.
3. Refer to
Chapter 3: Schematics and Chapter 7: Master Parts List to identify parts or assemblies
needing checkout or replacement.
4. Refer to
Chapter 5: Assembly/Disassembly for detailed instructions on removing and replacing
faulty components.
5. If you need additional help, refer to
Chapter 1: Safety and Support for information about
returning equipment or acquiring further assistance.
CAUTION General Warning
The Integrated Welder weighs 145 pounds. Handling, unpacking, and
installation can require help or the use of lifting platforms or hoists.
NOTICE
2000 IW/IW+ Series Integrated Welders should be serviced only by
qualified technicians using Branson-approved test and repair
equipment, repair procedures, and replacement parts. Unauthorized
attempts at repair or modification of the welder will void the
warranty.
To Next Page
Loading...
