Emerson 2000IW - Figure 5.15 Removing the Controller Board

88 1019567 REV. 03
5.5.2.1 Removing the Controller Board
Figure 5.15 Removing the Controller Board
CAUTION General Warning
Be careful not to leave any loose components (such as screws, bolts,
nuts, and so forth) in the welder.
NOSE COVER
EDP 100-032-550
SNAP-IN STAND-OFF (4)
EDP 200-096-095
PROGRAMMER BOARD
OF THE CONTROL
MODULE
EDP 102-242-720R
TOOTH WASHER (4)
EDP 200-114-110R
EDP 200-073-154
J30
J35
P30
P35
DISPLAY BOARD OF THE
CONTROL MODULE
IW EDP 100-242-1201R
IW+ EDP 100-242-1202R
HEX NUT