1019567 REV. 03 125
• Place the float into the bowl (Figure 6.2 Disassembly of Air Filter Components)
• Screw the filter element into the housing until finger-tight
• Screw the bowl into the housing
6.1.4 Manual Tuning
If there is an instance where Autotune does not provide proper tuning, using the following
procedure.
Remove the Autotune label from the Front Panel.
NOTICE
This should NOT be a regularly performed procedure, but should be
used only as a last resort.
CAUTION General Warning
Do not force the potentiometer beyond its stop limits. The total
rotation from full cw to full ccw is only 270°.
To Next Page
Loading...
