28 1019567 REV. 03
2
Ground Detect
(15 pin female)
An optional 2000IW only feature - allows
ultrasonic energy to be turned off when the
horn comes in contact with your electrically
isolated fixture or anvil. Requires Ground Detect
Kit, 101-063-343. Connector 2 is 15 pin female,
connector 3 is 3 pins.
3 Ground Detect (3 pins)
4 User I/O, Alarm Connector
25 pin D-shell connector provides a +24V DC
interface for external controls and devices.
ALARMS, WELD ON and EXTERNAL RESET
signals are available. In addition, a READY
signal is available as both +24V DC and isolated
contact closure. Using this connector, selected
faults or weld errors sensed by the welder can
be communicated outside the welder for
monitoring cycles and sorting suspect
workpieces. Connector 4 is a 25 pin female.
5 Start Connector
Connects the welder to its base or to customer
supplied start signals. Connector 5 is a 9 pin
male.
6 Air Filter
Filters contaminants from the air entering the
welder.
7 Line Cord Connects the welder to your power source.
Table 2.4 Rear Panel Connectors
Item Description Function
To Next Page
Loading...
