68 1019567 REV. 03
5.3.1 Opening and Removing the Left Side Cover
1. Turn off the welder and unplug main power.
2. Turn air pressure to zero; then disconnect the main air supply.
3. Loosen the two captive screws (
Figure 5.2 Opening the Left Side Cover, screws 1 & 2); then
loosen the remaining captive screws (
Figure 5.2 Opening the Left Side Cover, screws 3 to 6).
4. To remove the cover, hold the cover while tapping up on the bottom of the cover until the cover
comes off the hinges.
5.3.2 Replacing the Left Side Cover
To close or replace the left side cover, reverse the instructions for removing.
WARNING General Warning
Turn air pressure to zero and disconnect the main air supply. Failure
to do this leaves the welder under potentially dangerous air pressure.
NOTICE
Removing the left side cover is optional - for most repairs you only
need to open the cover.
CAUTION General Warning
Before closing the left side cover, make sure that all wires and tubing
will not get crimped when you close the left side cover.
To Next Page
Loading...
