Emerson Aventics G3 Series - Hub Module: Advanced Settings and Configuration

G3 Series EtherCAT
TM
Technical Manual
11-117
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Hub Module / Identification
1) Identifies HUB module in G3 System.
Hub Module / Description
2) Identifies Module type.
Hub Module / Advanced Settings
3) Allows the user to set/configure module
parameters.
Press the SET button to advance to the first
parameter/setting.
A) Press the SET button to enter the Set
Brightness sub-menu and highlight the
selection.
B) Press the NEXT button to select the desired
Brightness selection, (Low, Medium, High).
C) Press the SET button to slect the desired
Brightness level.
Screen Jumps to Next Parameter/Selection
A) Press the SET button to enter the Flip
Display sub-menu and highlight the selection.
B) Press the NEXT button to select the desired
Flip Display selection, (Normal, Flipped).
C) Press the SET button to select the desired
display orientation.
D) Press NEXT to advance to the next
parameter selection (Branch Reserve)
FLIP DISPLAY
FLIPPED
DESCRIPTION
SUB-BUS HUB
BRIGHTNESS
HIGH
FLIP DISPLAY
NORMAL
Brightness
Flip Display
SUB-BUS HUB
1
ADVANCED
SETTINGS
SET
BRIGHTNESS
BRIGHTNESS
LOW