G3 Series EtherCAT
TM
Technical Manual
13-134
Subject to change without notice
www.asco.com/g3
10. Choose the option marked “Use the following IP address” and type in an IP address that has the same first
three octets as the address that you will set the manifold to. For the last octet you may choose any number
from 0-255, just make sure that it is not the same number as the IP address that the manifold will have.
Make sure your subnet mask is set to “255.255.255.0” (this value can be changed, but this value will be used
for demonstration purposes).
11. Left click “OK” in the “Internet Protocol (TCP/IP) Properties” and “Local Area Connection” windows for the
changes to take effect on the computer. Close out of any open windows.
Once the IP address for the computer is known, you can set the IP address of the Aventics manifold using one of
the methods described on page 5-33 .
12. Click on “start” then select “All Programs->Accessories->Run”.
To Next Page
Loading...
