Emerson Aventics G3 Series - Diagnostics: Node Information and Valve Status

G3 Series EtherCAT
TM
Technical Manual
13-140
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Relevant node
information
including
firmware
revision
“Diagnostic
word” data
Graphic of
module
Shows diagnostic
status of whether
coils are shorted
or open.
Valve coil forcing
capability. Can
be disabled with
password
*Note
The G3 node must be switched to Pre-Operational mode via the Twincat system
manager software to allow forcing output states from the G3 webpage. See next
page