Emerson E300 Series - Page 116

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
116 E300 Design Guide
Issue Number: 1
Figure 5-9 NV Media Card operation, programming drive
Table 5-10 NV Media Card part numbers
Table 5-11 SMARTCARD and SD card codes
Where yyy indicates the block number 001 to 999.
If the NV Media Card read only flag, 9888 is set then only codes 6yyy or 9777 are effective.
Parameter N01 = Read +
Drive reads all
parameters from
the media card
Parameter N01 = Auto +
Auto
Save
Drive automatically
writes to the media
card when a
parameter
save is performed
Parameter N01 = Boot +
Boot
Auto Save
Drive boots from the
mon
power up and
automatically writes
to the media card
when a parameter
save is performed
edia card
NV media card Part number
SD card Adaptor (memory card not included) 3130-1212-03
8 kB SMARTCARD 2214-4246-03
64 kB SMARTCARD 2214-1006-03
Code Operation SMARTCARD SD card
2001 Transfers all drive parameters (including SI options) to parameter file 001 and sets the block as bootable.
99
4yyy Transfers all drive parameters (including SI options) to parameter file yyy.
99
6yyy Load the drive parameters from parameter file yyy
99
7yyy Erase parameter file yyy.
99
8yyy Compare drive parameters with parameter file yyy.
99
9555 Clear the warning suppression flag
99
9666 Set the warning suppression flag
99
9777 Clear the read-only flag
99
9888 Set the read-only flag
99
9999 Erase and format the NV Media Card
9
15yyy Transfer a program from an option module in slot 1 to a option module applications file
9
16yyy As 15yyy, but for slot 2
9
17yyy As 15yyy, but for slot 3
9
18yyy Load a program to the option module in slot 1 from an option module applications file
9
19yyy As 18yyy, but for slot 2
9
20yyy As 18yyy, but for slot 3
9
21yyy As 15yyy, but for slot 4
9
22yyy As 18yyy, but for slot 4
9
40yyy
Backup all drive data (parameter differences from defaults, applications programs and miscellaneous
options module data), including the drive name; the store will occur to the </MCDF/driveyyy/> folder on
the NV Media Card; if it does not exist, it will be created. Because the name is stored, this is a backup,
rather than a copy. The command will clear when all drive and option module data is saved.
9
60yyy
Load all drive data (parameter differences from defaults, applications programs and miscellaneous
options module data); the load will come from the </MCDF/driveyyy/> folder on the NV Media Card. The
command code will clear once all drive and option module data has been loaded.
9
NOTE