Emerson E300 Series - Installing; Removing Option Modules, Keypad

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
32 E300 Design Guide
Issue Number: 1
A grommet kit is available for size 7 finger guards.
Table 3-1 Grommet kit (size 7)
3.4 Installing / removing option modules, keypad
Figure 3-4 Installation of a standard option module
Option module slots must be used in the following order: slot 3, slot 2 and slot 1
Installing the first option module
• Move the option module in direction shown (1).
• Align and insert the option module tab in to the slot provided (2), this is highlighted in the detailed view (A).
• Press down on the option module until it clicks into place.
Drive size Part number Picture
Size 7 - Kit of 8 x single entry grommets 3470-0086-00
Power down the drive before installing / removing the option module. Failure to do so may result in damage to the product.
CAUTION
NOTE