Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A
Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 185
Issue Number: 1
At power up, if Parameter Cloning Modes (N01) is set to Auto (3), the drive will save the complete parameter set to the NV Media Card. The drive will
display 'Card Write' during this operation. This is done to ensure that if a user puts a new NV Media Card in during power down the new NV Media
Card will have the correct data.
Refer to NV Media Card operation in the previous section on Programming the drive for diagnostic information when using the NV Media Card.
When Parameter Cloning Modes (N01) is set to Auto (3) the setting of Parameter Cloning Modes (N01) itself is saved to the drive EEPROM but not
the NV Media Card.
7.26 Elevator Connect PC tool
The discovery protocol feature which is supported on the Elevator Connect PC tool is able to discover drives automatically which are connected to a
PC.
To allow operation with the Elevator Connect PC tool on the E300 Advanced Elevator Drive a communications option is required.
To Next Page
Loading...
