Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A
Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
176 E300 Design Guide
Issue Number: 1
Table 7-35 UPS power control parameter
Figure 7-22 Emergency power supply backup control
Parameter Detail
Ups Control Enable (O05) Enable, disable for UPS control
UPS Maximum Power Set point
(O06)
Maximum UPS power in kW. This setting prevents the UPS from being overloaded during emergency evacuation
with UPS control enable = On (1).
UPS evacuation current full load
limit (O07)
Defines the percentage full load current allowed during emergency evacuation with UPS control enable = On (1)
to prevent overloading, and to extend the operating time of the UPS power supply.
UPS evacuation current no load
limit (O08)
Defines the percentage no load current allowed during emergency evacuation with UPS control enable = On (1)
to prevent overloading, and to extend the operating time of the UPS power supply.
1
J58
Output power
UPS maximum
power setpoint
O06
0
Active speed
setpoint
Standard
speed
selection
0
0
Current full
load O07
Current no
load O08
B16 I-max %
DC Bus
J64
550 V
450 V
J64
DC Bus voltage
Symmetrical current
limit stored value
Symmetrical
current limit
Symmetrical
current limit
1
0
1
0
B16
UPS control
enable
UPS control
enable
O05
O05
To Next Page
Loading...
