Emerson E300 Series - Page 367

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 367
Issue Number: 1
See Drive Identifier Characters (J91).
See Drive Identifier Characters (J91).
Drive Derivative (J96) shows the derivative identifier.
When set to On (1), this indicates that the elevator speed is <= 200 mm/s.
When set to Off (0), this indicates that the elevator speed is > 200 mm/s
J94 Extra Identifier Characters 2
Mode Open-Loop, RFC-A, RFC-S
Minimum -2147483648 Maximum 2147483647
Default Units
Type 32 Bit Volatile Update Rate Power-up write
Display Format String Decimal Places 0
Coding RO, ND, NC, PT
J95 Extra Identifier Characters 3
Mode Open-Loop, RFC-A, RFC-S
Minimum -2147483648 Maximum 2147483647
Default Units
Type 32 Bit Volatile Update Rate Power-up write
Display Format String Decimal Places 0
Coding RO, ND, NC, PT
J96 Drive Derivative
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Volatile Update Rate Power-up write
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT, BU
J97 Velocity Threshold Status Output
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default Units
Type 1 Bit Volatile Update Rate 4 ms
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT