Emerson E300 Series - Page 381

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 381
Issue Number: 1
See Variable Selector 1 Source 1 (K30).
See Variable Selector 1 Source 1 (K30).
See Variable Selector 1 Source 1 (K30) for more details.
Variable Selector 1 Enable (K37) and Variable Selector 2 Enable (K52) have a default of 1 so that if these parameters are not used the variable
selectors will still function.
See Threshold Detector 1 Output (K23).
See Threshold Detector 1 Output (K23).
K35 Variable Selector 1 Source 2 Scaling
Mode Open-Loop, RFC-A, RFC-S
Minimum -4.000 Maximum 4.000
Default 1.000 Units
Type 16 Bit User Save Update Rate 4 ms read
Display Format Standard Decimal Places 3
Coding RW
K36 Variable Selector 1 Control
Mode Open-Loop, RFC-A, RFC-S
Minimum 0.00 Maximum 100.00
Default 0.00 Units
Type 16 Bit User Save Update Rate 4 ms read
Display Format Standard Decimal Places 2
Coding RW
K37 Variable Selector 1 Enable
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default 1 Units
Type 1 Bit User Save Update Rate 4 ms read
Display Format Standard Decimal Places 0
Coding RW, BU
K38 Threshold Detector 2 Output
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default Units
Type 1 Bit Volatile Update Rate 4 ms write
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
K39 Variable Selector 2 Source
Mode Open-Loop, RFC-A, RFC-S
Minimum A00 Maximum AB99
Default A00 Units
Type 16 Bit User Save Update Rate Drive reset read
Display Format Menu Param Alpha Numeric Decimal Places 3
Coding RW, PT, BU