Emerson E300 Series - Page 489

E300 Design Guide 489
Issue Number: 1
N
NEMA rating ...........................................................43, 484, 485
Nominal elevator speed ........................................................158
Notes .........................................................................................8
O
Open loop mode ......................................................................16
Operating mode (changing)
..................................................118
Operating-mode selection .....................................................129
Optimization ..........................................................................474
Option Module
.......................................................................425
Options ....................................................................................19
Output contactor ......................................................................93
Output frequency
...................................................................485
P
Parameter ranges .................................................................187
Parameter security ................................................................109
Parameter x.00
......................................................................129
Planning the installation
..........................................................29
Position feedback module category parameters ...................425
Power ratings
..........................................................................95
Power terminals
......................................................................48
Precision reference Analog input 1 .........................................70
Product information .................................................................10
Q
Quadratic V/F mode ................................................................16
R
Reactor current ratings ............................................................90
Relay contacts
.........................................................................72
Residual current device (RCD) ................................................97
Resistances (minimum) ...........................................................95
Resolution
.............................................................................486
RFC-A mode ...........................................................................16
RFC-S mode ...........................................................................16
Routine maintenance
..............................................................56
S
SAFE TORQUE OFF ............................................................104
SAFE TORQUE OFF/drive enable
..........................................72
Safety Information
...............................8, 10, 29, 186, 439, 484
Saving parameters
................................................................119
Serial comms lead
...................................................................67
Serial communications connections
......................................104
Serial communications look-up table
.....................................454
Serial communications port isolation
.......................................66
Speed limits
...........................................................................128
Speed loop gains ..................................................................475
Speed range ..........................................................................485
Start up time
..........................................................................485
Starts per hour ......................................................................485
Status ....................................................................................443
Status Indications
..................................................................443
Storage ..................................................................................484
Supply types ............................................................................59
Surface mounting the drive
.....................................................35
Surge immunity of control circuits - long cables and
connections outside a building ........................................103
Surge suppression for analog and bipolar inputs and
outputs
............................................................................104
Surge suppression for digital and unipolar inputs
and outputs
.....................................................................103
T
Temperature ......................................................................... 484
Terminal block in the enclosure ............................................ 103
Terminal cover removal .......................................................... 30
Terminal sizes
........................................................................ 48
Thermal protection circuit for the braking resistor .................. 96
Through-panel mounting the drive .......................................... 38
Torque settings
....................................................................... 49
Trip ....................................................................................... 436
Trip Indications ..................................................................... 436
U
User Menu A ......................................................................... 122
User Security
........................................................................ 109
V
Ventilation ............................................................................... 42
Vibration ............................................................................... 485
Voltage boost
........................................................................ 135
W
Warnings ................................................................. 8, 191, 484
Weights
................................................................................. 487