Emerson iPro Series - 4.8.3.7 Electrical specifications; 4.8.3.8 Plastic container; 4.8.3.9 Setting the address of the device

1592025700 IPROFAMILY 3.5 stp GB 2016.12.07 iPro Series 54/96
4.8.3.7 Electrical specifications
Power Supply:
24Vac +10/-15%, 50/60Hz
20 - 36Vdc
Consumption:
10VA (Vac), 10W (Vdc)
Connectors:
Molex connectors with low voltage wiring (for IPX306D)
Phoenix quick coupling connectors for low voltage (for IPX206D)
STELVIO 90° screw connectors for digital outputs (250Vac, 6A max)
4.8.3.8 Plastic container
Mount:
On a DIN rail (EN 50022, DIN 43880)
Fastened with screws via the removable plastic flaps.
Material:
PC-ABS Thermoplastic
Self-extinguishing:
V0 (UL94)
Comparative Tracking Index (CTI):
300V
Colour:
Black
4.8.3.9 Setting the address of the device
The address of the device is set via a dip-switch and numbering is binary as shown in the table
below:
If the address is changed while the device is switched on, to confirm the new address
remember to switch off and switch on again the device.
Not used