Emerson Rosemount 3100 Series Reference Manual

127
Reference Manual
00809-0100-4840, Rev CB
Appendix F: Programming the 3102 and 3105 using HART
February 2015
Programming the 3102 and 3105 using HART
F.2.8 Load defaults
This restores the transmitter parameters to the factory default values for the selected base
units. This is sometimes necessary, particularly if the data held in the transmitter is in doubt.
Note
Restoring the factory defaults values overwrites all site entered data. After loading the factory
defaults, the transmitter automatically re-starts and communication is interrupted until the
re-start is complete.
Field Communicator or AMS Device Manager
To restore the factory default settings
of the transmitter
1. From the Home screen, select 3: Service Tools.
2. Select 4: Maintenance.
3. Select 3: Utilities.
4. Select 2: Load Defaults.
5. When the message “About to restore factory defaults” appears, select “OK” to continue
(or “ABORT” to not continue).
6. Select 1: Yes to restore the factory defaults.
Note
When messages appear, take appropriate action if needed and select “OK”.
Rosemount 3490 Series Control Unit
To restore the factory default settings
of the transmitter
1. From the Main Menu screen, select SETUP.
2. Select the transmitter (e.g. “Tx1: 3102”).
3. Select SYSTEM, and then select DEFAULTS.
4. Follow the on-screen instructions (select “Start” and answer “Yes”)
to restore the factory defaults. Use the Enter ( ) key if prompted to change the mode
to “off-line”.
5. Select “Quit” to exit to the previous menu.
Fast Keys
3, 4, 3, 2
Utilities
1. Restart Device
2. Load Defaults
3. Set Base Units
2. Load Defaults
SAVE
HOME
HELP
(Field Communicator Screen Shown)
LOADS FACTORY
DEFAULT VALUES
Esc=Quit =Start
DEFAULTS
(Rosemount 3491 Screen Shown)

Emerson Rosemount 3100 Series Specifications

General

Brand	Emerson
Model	Rosemount 3100 Series
Category	Transmitter
Language	English