Reference Manual
00809-0100-4840, Rev CB
Section 4: Starting up
February 2015
23
Starting up
Section 4 Starting up
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 23
Programming the Rosemount 3101, 3102, and 3105 Transmitters . . . . . . . . . . . . . . . .page 24
Programming the 3101 using the integral display and buttons . . . . . . . . . . . . . . . . . . .page 26
Programming the 3102 and 3105 using the integral display and buttons . . . . . . . . . . .page 35
4.1 Safety messages
Procedures and instructions in this section may require special precautions to ensure the safety
of the personnel performing the operation. Information that raises potential safety issues is
indicated by a warning symbol ( ). Refer to the following safety messages before performing
an operation preceded by this symbol.
Explosions could result in death or serious injury.
Verify that the operating environment of the gauge is consistent with the appropriate
hazardous locations certifications.
Before connecting a HART
®
-based communicator in an explosive atmosphere, make
sure the instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Do not remove the gauge cover in explosive atmospheres when the circuit
is alive.
Failure to follow safe installation and servicing guidelines could result in death or serious
injury.
Make sure only qualified personnel perform the installation.
Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
Do not perform any service other than those contained in this manual unless you are
qualified.
To Next Page
Loading...
Need help?
General
