• microSD card holder
• User EEPROM
• eMMC managed NAND flash (PE1-300/400)
• PCIe ×4 interface
• USB 3.0 device connector
• USB 2.0 host connector (PE1-200: 1 connector; PE1-300/400: 4 connectors)
• Micro USB 2.0 device (UART, SPI, I2C, JTAG) connector
• 2 × RJ45 Gigabit Ethernet connectors
• mPCIe/mSATA card holder (USB only) (PE1-300/400)
• SIM card holder (optional, PE1-300/400 only)
• SMA clock and data in/out (optional, PE1-300/400 only)
• 1 × FMC LPC connector (PE1-200)
• 1 × FMC HPC connector (PE1-300)
• 2 × FMC LPC connector (PE1-400)
• 2 × 40-pin Anios pin header
• 3 × 12-pin Pmod™ pin header
• 5 to 15 V DC supply voltage
• USB bus power (with restrictions)
Please note that the available features depend on the equipped Mercury module type and on the selected
base board variant.
1.5 Xilinx Tool Support
The SoC devices equipped on the Mercury ZX1 SoC module are supported by the Vivado HL WebPACK
Edition or by the Vivado HL Design Edition software, depending on the device’s density. Table 1 presents
the correspondence between devices and tools. Please contact Xilinx for further information.
Module Xilinx Tool Support Costs
ME-ZX1-30 Vivado HL WebPACK Edition Free of charge
ME-ZX1-35 Vivado HL Design Edition Paid license required
ME-ZX1-45 Vivado HL Design Edition Paid license required
Table 1: Xilinx Tool Support
D-0000-403-002 9 / 56 Version 05, 25.07.2019
To Next Page
Loading...
