Endress+Hauser Proline Promass F 300 - Page 119

Proline Promass F 300 EtherNet/IP Commissioning
119
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Minimum frequency value In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  118):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Concentration
*
• Temperature
• Carrier pipe temperature
*
• Electronic temperature
• Oscillation frequency 0
• Frequency fluctuation 0
• Oscillation amplitude 0
*
• Oscillation damping 0
• Oscillation damping
fluctuation 0
• Signal asymmetry
• Exciter current 0
Enter minimum frequency. 0.0 to 10 000.0 Hz 0.0 Hz
Maximum frequency value In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  118):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Concentration
*
• Temperature
• Carrier pipe temperature
*
• Electronic temperature
• Oscillation frequency 0
• Frequency fluctuation 0
• Oscillation amplitude 0
*
• Oscillation damping 0
• Oscillation damping
fluctuation 0
• Signal asymmetry
• Exciter current 0
Enter maximum frequency. 0.0 to 10 000.0 Hz 10 000.0 Hz