Endress+Hauser Proline Promass F 300 - Page 145

Proline Promass F 300 EtherNet/IP Commissioning
145
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable
→  145
Unit totalizer 1 to n
→  145
Totalizer operation mode
→  146
Failure mode
→  146
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer.
• Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Target mass flow
*
• Carrier mass flow
*
• Target volume
flow
• Carrier volume
flow
• Target corrected
volume flow
• Carrier corrected
volume flow
• GSV flow
• GSV flow
alternative
• NSV flow
• NSV flow
alternative
• S&W volume flow
• Oil mass flow
• Water mass flow
• Oil volume flow
• Water volume flow
• Oil corrected
volume flow
• Water corrected
volume flow
Mass flow
Unit totalizer 1 to n One of the following options is
selected in the Assign process
variable parameter
(→  145) of the Totalizer
1 to n submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Select process variable totalizer
unit.
Unit choose list Country-specific:
• kg
• lb