Section 14: In Case of Difficulty
176
Problem: Computer error or print error message (such as: “There was an
error writing to LPT1…”) appears on your computer screen.
Solution:
1. Verify that the Legend is READY (press the “GO” key).
2. Is the printer cable connected correctly? Review the hookup configuration.
3. If you have multiple LPT printer ports, make sure you are printing with the one
connected to the engraver.
4. Always delete any print job that did not transmit properly. Do not leave part of
the design waiting for transmission. Sending another job with one waiting in
the print queue will complicate matters. Reboot the Legend to clear all print
jobs.
5. Any other error reported to your computer screen is going to be an internal
computer error. There is either a problem with the computer's hardware and/or
software. Contact a reputable computer representative for assistance.
Problem: Raster engraving errors when you print from Corel 9. The error is a
series of dots that extend to the edge of the page that you are engraving.
Solution:
¾ Refer to “Section 5 – Configuring CorelDraw”, of this manual for solution under
subheading “Installing and using the WIN XP/2000 Color Mapping print driver with
Corel 9”
To Next Page
Loading...
Need help?
General
