Epson AcuLaser C2800 - Page 206

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 206
Confidential
CONTROL PANEL
 Be careful not to drop or damage the CONTROL PANEL.
 Be sure not to remove the CONTROL PANEL from the COVER FRONT ASSY too far
as they are connected with a harness.
1. Release the two tabs on the CONTROL PANEL, and remove the CONTROL PANEL from the
COVER FRONT ASSY.
2. Disconnect the CONTROL PANEL connector (CN1) and the HARNESS ASSY-CON F terminal.
D
Kmy03013E
A
1)-1
1)-1
1)-2
2)
CONTROL PANEL
PLATE LATCH
SPRING LATCH
LATCH FRONT
Confirm if the PLATE LATCH moves smoothly by pressing the BUTTON TOP.
1. Remove the SPRING LATCH from the tabs of the PLATE LATCH and the COVER FRONT ASSY.
Install the SPRING LATCH as shown in figure-A.
2. Remove the screws (silver, brimmed, self-tapping, 10 mm) that secure the two LATCH FRONTs to
the COVER FRONT ASSY.
3. Slide the PLATE LATCH and the LATCH FRONT in the direction of the arrow, and remove them
from the COVER FRONT ASSY.
NEXT>>
D
Kmy03011EB
1)
2)
2)
3)
Figure-A
SPRING LATCH