Epson AcuLaser C2800 - Controller Specifications

EPSON AcuLaser C2800/C2800D/C3800/C3800D Revision C
PRODUCT DESCRIPTION Product Specifications 25
Confidential
1.2.4 Controller Specifications
BASIC SPECIFICATIONS
*1: In AcuLaser C2800/C2800D's case, an add-on memory can be installed in the S1 slot only.
CPU AcuLaser C2800/C2800D : PowerPC750FL (400 MHz)
AcuLaser C3800/C3800D : PowerPC750FL (600 MHz)
Enhanced technology CPGI, CRIT, RIT (FMV)
RAM DDR333 200 pin SO DIMM, CL=2.5
Standard 128MB (S0 slot)
Maximum AcuLaser C2800/C2800D : 640MB (128MB + 512MB)
AcuLaser C3800/C3800D : 1GB (512MB + 512MB)
Expansion 128MB, 256MB, 512MB (1 slot (S1 slot))
*1
ROM 32-bit width (3.3 V)
Program 16MB (P slot)
Font Included in the program
Expansion Optional Flash DIMM (A slot)
Control panel 22 digits x 5 lines LCD, three LEDs, six buttons
Printer setting Panel settings, EJL, PJL, HTTP, SNMP, and ENPC
Stored in 256 K bit serial type EEPROM
Printer mode Standard
 ESC/ Page-Color  ESCP2 (B/W)
 I239X (B/W)  Adobe PostScript3
 PDF1.3  PCLXL
 FX (B/W)  ESC/Page (B/W)
 PLC5c
Other EJL, PJL, and RCC modes (for firmware update)
DIAG mode (engine adjustment)
Auxiliary software  Status sheet
 Toner check sheet
 EpsonNetConfig(Web)
 Hex dump
 Reserve job list
 PS3 status sheet
 Support mode
 Form overlay list
 Network status sheet
 Font sample (for each mode)
 Printer adjust menu
 AUX status sheet (only when Type-B level 3 is installed)
 USB Ext I/F status sheet (only when connected to D4
compliant USB devices)
 Maintenance mode (Engine status sheet)
 EFU (for engine firmware update, only when a Flash is
installed as a mechanical controller ROM)
C H E C K
P O I N T
When adding more RAM to the printer, standard RAM DIMM
(64MB) should also be replaced according to the capacity of the
add-on memory.
e.g.) When upgrading to 1024MB, remove the standard RAM
DIMM and install two 512MB DIMMs.