AcuLaser C2800/C2800D/C3800/C3800D Revision C
TROUBLESHOOTING FIP 85
Confidential
3.2.4 List of Service Request
Table 3-3. List of Service Request
Class Code Description See FIP
Engine Related (E)
100 Laser power has weakened.
SOS signal cannot be detected.
FIP 1-24 (p.103)
300 Abnormal high temperature was detected
The printer detected that the circuit for the Temp sensor is in failure.
Abnormal low temperature was detected
Warm-up has not completed within the specified time.
The lamp remains lit longer than the specified time.
FIP 1-25 (p.104)
500 Abnormal rotation signal of Main/Sub/Deve Motor (DRIVE ASSY MAIN) or the PH Motor (DRIVE ASSY PH) is detected. FIP 1-26 (p.105)
550 Abnormal rotation signal of the FAN MAIN/FAN DUP is detected. FIP 1-27 (p.106)
600 Output of the ADC Sensor inside the TRANSFER UNIT is decreased. FIP 1-28 (p.107)
610 High temperature, low temperature, or high humidity that goes out of bounds is detected. FIP 1-29 (p.108)
900 NV-RAM in the PWBA MCU error
Communication error between the PWBA MCU and the PWBA EEPROM, CRUM in the FUSER UNIT, CRUM in the TRANSFER UNIT, or the
HVPS.
FIP 1-30 (p.109)
901 Firmware error FIP 1-31 (p.109)
998
Engine communication error
FIP 1-32 (p.110)
Controller Related (C)
0000-0799 CPU exception (controller or software failure)
“3.4 Controller-
related Trouble FIP
(p133) ”
0800 IPL error (controller defect)
0998 Engine communication error (only when power-on)
0999 Engine flash ROM has no program data
1000 Standard RAM error (not installed, etc.)
1001 Standard RAM error (minimum stack is undefined, etc.)
1002 Standard RAM error (standard size is undefined, etc.)
1003 Optional RAM error
1010 Verification error
1020 RAM error (slot 0)
1021 RAM error (slot 1)
1022 RAM error (slot 2)
1100 ROM checksum error (bit 0 to 15) (font)
1101 ROM checksum error (bit 16 to 31) (font)
To Next Page
Loading...
