Epson AcuLaser C2800 - Page 235

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 235
Confidential
ROLL ASSY MSI
1. Remove the SPRING FEED MSI from the main unit.
Mind the correct orientations when installing the SPRING FEED MSI.
 Install the SPRING FEED MSI so that its oval figure side is attached to the main unit.
2. Release the tab of the GEAR MSI and remove the GEAR MSI from the SHAFT MSI.
Make the D-cut surface of the SHAFT MSI face upward for easier operation.
NEXT>>
A
B
Kmy03080E
A
2)-1
2)-2
1)
Attach to
the main unit
Attach to
GEAR MSI
3. Remove the E-rings on the left and right edges of the ROLL ASSY MSI that secure the BEARINGs,
and slide the BEARINGs inward.
Be careful not to lose the BEARING EARTH and the BEARING.
4. Temporarily slide the ROLL ASSY MSI to the right, pull out the left end of the ROLL ASSY MSI
from the main unit, and remove the ROLL ASSY MSI.
5. Remove the BEARING EARTH and the BEARING from the ROLL ASSY MSI.
Mind the correct orientations when installing the BEARING EARTH and the BEARING.
 Color of the BEARING EARTH on the right side is black.
 Color of the BEARING on the left side is white.
White
Kmy03021EA
3)-1
3)-1
3)-2
4)
5)
5)
3)-2
Black
ROLL ASSY MSI