Epson AcuLaser C2800 - Page 275

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 275
Confidential
DISPENSER ASSY (K), (C), (M), (Y)
C H E C K
P O I N T
 There are four MOTOR ASSY Gasps and they can be removed in the same manner.
 The mid-connector should remain connected to the main unit.
1. Release the connectors and the harnesses of the four MOTOR ASSY DISPs from the DUCT
HARNESS MOT, and disconnect the connectors of the MOTOR ASSY DISPs.
2. Release the two tabs that secure the DUCT HARNESS MOT to the main unit.
3. Slightly slide the DUCT HARNESS MOT upward, release the protrusion of the DUCT HARNESS
MOT from the main unit, pull out the four connectors of the MOTOR ASSY DISP through the holes
in the DUCT HARNESS MOT, and remove the DUCT HARNESS MOT.
NEXT>>
A
Kmy03038E
A
2)
2)
3)
1)
1)
1)
1)
2)
4. Remove the screw (silver, self-tapping, 8 mm) that secures the MOTOR ASSY DISP to the main
unit.
5. Slightly slide the MOTOR ASSY DISP toward front side of the printer, release the protrusion of the
MOTOR ASSY DISP from the main unit, and remove the MOTOR ASSY DISP.
Kmy03039E
A
4)
5)
DISPENSER ASSY (K)
DISPENSER ASSY (C)
DISPENSER ASSY (M)
DISPENSER ASSY (Y)