Epson AcuLaser C2800 - Page 408

EPSON AcuLaser C2800/C2800D/C3800/C3800D Revision C
APPENDIX Firmware Update 408
Confidential
6 Transmit the data
Click [Send] on the Firmware Update Tool window. Click [Send] on the Firmware Update Tool window.
7 Perform the update
When the printer starts to receive the file or begins
rewriting, the data LED flashes and the message “ROM P
Writing” appears on the LCD panel.
When the transfer is complete, the “Completion” window
pops up. Click [OK].
Confirm that both old and new firmware versions are
displayed on the LCD panel, and press the [ ] button
on the control panel.
The “Completion” window will be displayed when the
data transfer is finished. Click [OK].
8 Confirm the checksum
---
When the program update is finished, the checksum
appears on the LCD panel.
Confirm the checksum.
9 Reboot the printer
After confirming the data LED is turned off and the LCD
panel displays “Ready”, turn the printer power off and
turn back on again.
Press [ ].
The printer automatically reboots.
---
Procedure
Method 1 Method 2
LCD Panel
(RCC) (CRB)
Program Device
Version XX.XX
OLD: XXXX NEW: XXXX
Program Device
Version XX.XX
Erasing Device
Program Device
Version XX.XX
PRG XXXXXXXX
Program Device
Version XX.XX
Code=
XXXX, XXXX, XXXX, XXXX
Total=
XXXX, XXXX, XXXX, XXXX