Epson DFX-9000 - Interface Cover; Rear Unit

Epson DFX 9000 Revision B
Disassembly and Assembly INTERFACE COVER 133
4.2.2.2 INTERFACE COVER
1. Facing the rear of the printer, release the two tabs that secure the
INTERFACE COVER to the REAR UNIT, and open the
INTERFACE COVER.
2. Release one of the two hinge pins that secure the INTERFACE
COVER to the LOWER UNIT while pressing the tab in the direction
of the arrow, and remove the INTERFACE COVER straight back.
Figure 4-4. INTERFACE COVER Removal
4.2.2.3 REAR UNIT
1. Open the REAR UNIT and remove the four screws (two on either
side) that secure it to the printer.
2. Lift the REAR UNIT upward at an angle to remove it.
Figure 4-5. REAR UNIT Removal
tab
INTERFACE COVER
2)-1
2)-2
tab
LOWER UNIT
REAR UNIT
1)-1
1)-2
1)-2
2)
REAR UNIT