Epson DFX-9000 - Printer Mechanism

Epson DFX 9000 Revision B
Disassembly and Assembly PR MECHA ASY 149
4.2.4 Printer mechanism
4.2.4.1 PR MECHA ASY
1. Remove the UPPER UNIT (p. 135)
2. Lift one side of the PR MECHA ASY in the direction of the arrows
shown in Figure 4-23 holding the two rear lift handles, and keep the PR
MECHA ASY tilted up using the tilt bar.
3. Remove the C.B.S. 3 × 8 screw that secures the clamp for the OP
CABLE to the SIDE FRAME, RIGHT, and release the OP CABLE.
Figure 4-23. PR MECHA ASY Removal (1)
W A R N I N G
 Do not touch the motors immediately after using the
printer, or you may burn your hand. Allow the motors
to cool enough to work with them.
 Be careful with the edges of the shield plate: they are
very sharp.
C A U T I O N
 When using the tilt bar, be careful not to let the tilt bar
interfere with the cables.
 Lift the PR MECHA ASY with great care so that the
plastic lift handles do not come off the side frames.
C A U T I O N
Handle the OP CABLE with care. It is shielded, and two
ferrite cores are attached to it for electromagnetic
interference prevention.
When attaching the OP CABLE, install the clamp to the
cable at the position shown in Figure 4-23 before fastening
the clamp and OP CABLE to the SIDE FRAME, RIGHT.
2)-1
Tilt Bar
2)-1
3)-2
3)
PR MECHA ASY
Lift handles
(rear and front)
OP CABLE
5)
Cable
Reassembly
Clamp Installation Position
Cotton
Tape
CAUTION
Lift handles
(rear and front)