Epson DFX 9000 Revision B
Disassembly and Assembly OC MOTOR 166
4.2.4.11 OC MOTOR
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. (Refer to section 4.2.4.1 PR MECHA ASY, p. 149.)
3. Release the OC MOTOR cable from the three cable clamps on the
bottom rear of the PR MECHA ASY.
4. Disconnect the OC MOTOR cable from the SENSOR BOARD
UNIT (CNO/C: 5 pins), and pull the OC MOTOR cable out through
the hole of the SIDE FRAME, LEFT.
5. Release the OC MOTOR cable from the retaining tab on the HCPP
SENSOR UNIT and the cable clamp on the SIDE FRAME, LEFT.
6. Remove the two C.P. (S-P1) 3 × 6 screws that secure the OC
MOTOR to the SIDE FRAME, LEFT, and remove the OC MOTOR
while sliding it so as not to interfere with the front gear.
W A R N I N G
Do not touch the OC MOTOR immediately after using the
printer, or you may burn your hand. Allow the motor to
cool enough to work with it.
C A U T I O N
When removing or installing the OC MOTOR, be careful
not to damage the front gear.
After installing the OC MOTOR, confirm that the CR
MOTOR pinion gear is securely engaged with the front
gear.
A D J U S T M E N T
R E Q U I R E D
Be sure to lubricate the OC gear and stud after removing or
replacing the OC MOTOR. See Figure 6-3. Lubrication
Point 3 (p.262)
To Next Page
Loading...
