Epson DFX-9000 - Selectype Functions Setting

Epson DFX-9000 Revision B
Product Description Operations 46
1.3.3 SelecType functions setting
SelecType allows you to change many of the printer’s operating settings.
These settings are stored in non-volatile memory, and become the
default settings each time the printer is initialized. To enter SelecType
and review or change settings, do the following:
1. Make sure paper is loaded.
2. Press the [Menu] (Tear Off + Top of Form) buttons to enter
SelecType mode. The LCD displays the selected language for this
mode.
3. If the language you wish is not selected, press the [Set↑] (Tear Off)
or [Set↓] (Top of Form) button until the LCD displays the preferred
language.
4. Press the [Item↓] (Pitch) button to set the desired language.
5. If you select Print Settings, press the [Set↓] (Top of Form) button to
print the current settings.
6. Press the [Item↑] (Font) or [Item↓] (Pitch) button to select the menu
parameters you wish to change.
7. Press the [Set↑] (Tear Off) or [Set↓] (Top of Form) button to select
the values within the selected parameter until you find the desired
setting.
8. After setting the selected parameter, you may either continue to
make changes to other parameters by pressing the [Item↑] or [Item↓]
button, or exit SelecType mode.
9. When you finish reviewing or changing the settings, press the
[Menu] (Tear Off + Top of Form) button.
10. The LCD displays “Save Setting”. If you wish to save the settings,
select “Yes” by pressing the [Set↑] (Tear Off) button. If you do not
want to save the settings, select “No” by pressing the [Set↓] (Top of
Form) button.
11. The printer exits SelecType mode.
C H E C K
P O I N T
The language you select is also used for other settings,
modes, and test printouts, such as default-settings and
printing a Hex Dump.
C H E C K
P O I N T
In Step 6 and 7 above, you can scroll the values by holding
down the [Set↑] (Tear Off), [Set↓] (Top of Form), [Item↑]
(Font), or [Item↓] (Pitch) button for a few seconds.
C H E C K
P O I N T
The SelecType menu is designed as a loop: It returns to the
beginning of the menu after the last available menu
parameter. See the SelecType function map, p. 47
SelecType only displays parameters that are valid for the
printer’s configuration. If no ethernet card is installed, for
example, the IP address section of the menu will not be
displayed.
C A U T I O N
If you turn off the printer prior to exiting the SelecType
mode, any changes you have made are canceled and not
saved.
C A U T I O N
Not all ethernet cards allow you to change their settings
with SelecType, and some do not display their settings.
Please confirm your settings once again with SelecType
mode.