Epson DFX-9000 - Hcpp Motor

Epson DFX 9000 Revision B
Disassembly and Assembly HCPP MOTOR 168
4.2.4.12 HCPP MOTOR
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. (Refer to section 4.2.4.1 PR MECHA ASY, p. 149.)
3. Release the HCPP MOTOR cable from the three cable clamps on the
bottom rear of the PR MECHA ASY.
4. Disconnect the HCPP MOTOR cable from the SENSOR BOARD
UNIT (CNHCPP: 5 pins), and pull the HCPP MOTOR cable out
through the hole in the SIDE FRAME, LEFT.
5. Release the HCPP MOTOR cable from the cable clamp on the SIDE
FRAME, LEFT.
6. Remove the two C.P. (S-P1) 3 × 6 screws that secure the HCPP
MOTOR to the SIDE FRAME, LEFT, and remove the HCPP
MOTOR while sliding it so as not to interfere with the front gear.
Figure 4-47. HCPP MOTOR Removal
W A R N I N G
Do not touch the HCPP MOTOR immediately after using
the printer, or you may burn your hand. Allow the motor to
cool enough to work with it.
C A U T I O N
 When removing or installing the HCPP MOTOR, be
careful not to damage the front gear.
 After installing the HCPP MOTOR, confirm that the
HCPP MOTOR pinion gear is securely engaged with
the front gear
SENSOR BOARD UNIT
4)-1 CNHCPP
Cable clamp
HCPP MOTOR
6)-1
6)-2
6)-1
[Front]
[Rear]
Front
Gear