Epson DFX-9000 - Adjustment

Epson DFX 9000 Revision B
Disassembly and Assembly TRACTOR UNIT 171
8. Remove the two C.P. (S-P1) 3 × 10 screws that secure the Sub shaft,
move the Sub shaft to the recess holes on the SIDE FRAME, LEFT
and SIDE FRAME, RIGHT, and then pull out the Sub shaft.
9. Remove the E-ring that secures the right end of the Tractor shaft, and
remove the washer, spring washer, and the bearing.
10. Pull out the Tractor shaft to the left.
Figure 4-50. TRACTOR FL UNIT/TRACTOR FR UNIT Removal (2)
Secure the FTRPE sensor cable with the cable clamps,
making length adjustments to meet the following
conditions:
 Too much tension should not be applied to the cable
when moving the TRACTOR FL UNIT to the right.
 The cable should not interfere with the Tractor shaft
when moving the TRACTOR FL UNIT to the left.
When installing the Tractor shaft, attach the spring washer
in the direction shown in Figure 4-50, Reassembly (A).
Place the Spring Washer with the bow facing the center of
the tractor shaft.
The TRACTOR FL UNIT and TRACTOR FR UNIT have
phases that must be matched. Align the phase marks of the
TRACTOR FL UNIT and TRACTOR FR UNIT before
installing the Tractor shaft. See Figure 4-50, Reassembly
(B).
8)-1
9)
Reassembly (A)
Spring washer
Tractor Shaft
E-Ring
8)-1
Recess hole
8)-2
Reassembly (B)
10)
Phase mark
Washer
Spring washer