Epson DFX-9000 - Safety Instructions

Epson DFX-9000 Revision B
Product Description Basic specifications 19
1.2.6.5 Overlapping multipart forms
Notes: 1. Print on overlapping multipart forms only under normal
temperature and humidity conditions.
2. Do not print on base sheets.
3. Do not feed paper in reverse direction.
4. Do not print overlapping multipart forms when the
perforation cutter is installed.
Figure 1-14. Overlapping multipart forms
Table 1-13. Overlapping multipart forms specifications
Item
Rear paper path Front paper path
Min. Max. Min. Max.
Base sheet
width
mm 76.2 419.1 76.2 419.1
inch 3 16.5 3 16.5
Base sheet
length
mm 76.2 558.8 76.2 558.8
inch 3 22 3 22
Total
thickness
mm 0.13 0.53 0.13 0.79
inch 0.0051 0.021 0.0051 0.031
Cut Sheet
(Multipart)
Base Sheet
Glue Point
Area
Perforation
Glue
Point
Area
More than 3.3 mm
(From the perforation to the top of
the next overlapping form)
Less than 17 mm
(From the perforation to
the bottom edge of the
glue point area)
The bottom edge of
the glue point
Less than 13.3 mm
(From the perforation to
the bottom edge of the
previous overlapping
form)
Less than
0.53 mm (Rear Entry)
0.79 mm (Front Entry)
(Total thickness including
glue point dilation)