Epson DFX-9000 - Adjustment

Epson DFX 9000 Revision B
Disassembly and Assembly DV ROLLER UNIT 179
The OC slide cam L and OC cam, and the OC slide cam R
and OC cam have phases that must be matched. Refer to
the figure below and install these parts so that the center of
the phase mark on the OC cam aligns with the window in
the Left and Right OC slide cam, respectively.
Figure 4-59. Reassembly the OC slide cam
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the following maintenance and
adjustments after removing the DV ROLLER F ASY.
1. Lubricate the gear and bearing. See Chapter 6, Shafts,
bearings and OC cam (p. 260), and Gears and slide
cams (p. 261).
2. LF drive belt tension adjustment (p. 222)
OC slide cam L
OC cam
OC slide cam R
Window in OC slide cam L (R) and phase mark on OC cam
Right sideLeft side