Epson DFX-9000 - Adjustment

Epson DFX 9000 Revision B
Disassembly and Assembly CARD GUIDE ASY 154
Figure 4-27. Cable Cover position during carrier holder reassembly.
Figure 4-28. TOF Sensor Cable Reassembly
 When installing the Carrier holder, replace the cable
protector correctly in the CARRIER UNIT. See Figure
4-27.
 When installing the CARD GUIDE ASY, thread the
TOF sensor cables as shown in Figure 4-28.
 Connect the two TOF sensor cables to the PCB
connectors, observing their orientation with reference
to Figure 4-28. Top side: the side covered with an
insulating and reinforcing strip. Bottom side: exposed
metal conductors.
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the following adjustments after
removing or replacing the CARD GUID ASY.
1. Card guide mount position adjustment (p. 227)
2. TOF sensor sensitivity adjustment (p. 235)
CARD GUIDE ASY
Carrier PCB
TOF sensor cable
Bottom
side:
exposed
conductor
Top side:
reinforcing
strip
Pass cables through
the square holes