Epson DFX-9000 - Adjustment

Epson DFX 9000 Revision B
Disassembly and Assembly Sensors 198
10. Slide the right-most Nip spring holder F and Nip spring F off of Nip
shaft F.
11. Slide the PJS HOLDER ASY and the PJS spring off of Nip shaft F,
and remove the PJS HOLDER ASY.
Figure 4-82. PJS HOLDER ASY Removal (3)
C A U T I O N
The Nip spring F and the PJS spring look similar, but vary
in shape - specifically, the number of coil turns. Do not
mistake Nip spring F for the PJS spring when you install
them.
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the following adjustments after
removing the PJS HOLDER ASY.
1. APTC UNIT mount position adjustment (p. 224)
2. LF drive belt tension adjustment (p. 222)