Epson DFX-9000 - Rf Motor

Epson DFX 9000 Revision B
Disassembly and Assembly RF MOTOR 163
4.2.4.9 RF MOTOR
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Release the RF MOTOR cable from the three cable clamps (SIDE
FRAME, RIGHT: 2 places, bottom rear: 1 place).
4. Release the RF MOTOR cable from the SENSOR BOARD UNIT
(CNRB: 4 pins), and pull the RF MOTOR cable out through the hole
in the SIDE FRAME, RIGHT.
5. Remove the two C.B.S. 3 × 6 screws that secure the RF MOTOR to
the SIDE FRAME, RIGHT, and remove the RF MOTOR.
Figure 4-42. RF MOTOR Removal
W A R N I N G
Do not touch the RF MOTOR immediately after using the
printer, or you may burn your hand. Allow the motor to
cool enough to work with it.
When installing the RF MOTOR, take care not to damage
the pinion gear attached to the motor when you pass it
through the hole in the side frame.
5)
5)
4)-1 CNRB
SENSOR BOARD UNIT
Cable clamp
Cable clamp
RF MOTOR
[Front]
[Rear]