Epson DFX-9000 - Adjustment

Epson DFX 9000 Revision B
Disassembly and Assembly SP BELT 158
4.2.4.5 SP BELT
1. Remove the SP MOTOR ASY (p. 156)
2. Remove the two C.B.S. 3 × 6 screws that secure the BELT clamp
that fastens the SP BELT to the CARRIER UNIT, and remove the
SP BELT.
Figure 4-36. SP BELT Removal
C A U T I O N
The Carrier PCB and a ferrite core is attached are attached
to the CARRIER UNIT. Handle them with care when
removing or replacing the SP BELT.
C A U T I O N
 When removing or installing the SP BELT, be careful
not to damage the CES SCALE.
 When installing the SP BELT, be careful not to
separate the CES SCALE from the CES sensor.
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the CR drive belt (SP BELT) tension
adjustment (p. 220) after removing or replacing the SP
BELT.
2)-1
2)-2
SP BELT
CES sensor
BELT clamp
CARRIER UNIT
CARRIER CABLE UNIT