Epson DFX-9000 - Top Margin Adjustment

Epson DFX 9000 Revision B
Adjustment Software adjustment 245
5.3.4 Top margin adjustment
This procedure adjusts the print start position from the top paper edge.
This adjustment is required after you remove or replace these parts:
 PR MECHA ASSY
 CARRIER UNIT
 LF BELT
 ROM BOARD (only when the EEPROM Data Copy fails)
Tools / materials: Adjustment Program
Paper: 1 sheet of 64 g/m
2
(17 lb)
Objective: Normal paper mode (Front/Rear tractor):
Margin A = 8.0 ~ 9.0 mm
Black paper mode (Front/Rear tractor):
Margin A = 7.5 ~ 9.5 mm
(See Figure 5-28.)
Adjustment Procedure
1. Set one sheet of paper on the tractor, and press the [Load] button on
the Operator Panel.
2. From the Adjustment Program, select Top Margin Adjustment.
3. Select either Front Tractor or Rear Tractor, depending on where
you loaded the paper.
Figure 5-27. Top Margin Adjustment screen
4. Click Print to print the top margin check pattern.