Epson DFX-9000 - Page 162

Epson DFX 9000 Revision B
Disassembly and Assembly CARD GUIDE ASY 155
Ribbon MASK
1. Remove the PRINT HEAD (p. 152)
2. Slowly bow toward you the left end of the Ribbon MASK as shown
in Figure 4-29. Release the Mask from the guide slot and pin that
secure the MASK to the left side of the CARD GUIDE ASY.
3. Release the MASK from the right guide slot and pin, and remove the
ribbon MASK.
Figure 4-29. MASK removal
Figure 4-30. MASK installation
Install the MASK as shown in Figure 4-30 by sliding it
down into the guide slots on both sides until the pins lock it
in place.
2)-2
3)
CARRIER UNIT
MASK
Pins
Guide
slot
2)-1
Pins
Guide slot