Epson DFX-9000 - Page 235

Epson DFX 9000 Revision B
Adjustment Hardware adjustment 228
3. Insert three sheets of paper into the gap between the card guide and
the platen as shown in Figure 5-8, and lightly push the card guide
against the paper. Then, secure the card guide in position by
tightening the two screws.
4. Refer to Figure 5-9 and verify that three sheets of paper fit in a gap
between the platen and the card guide, but four will not fit. If the gap
is not correct, repeat from the step 3.
Figure 5-8. Card Guide Mount Position Adjustment
Figure 5-9. Judging the Gap Level
0.3mm (0.28 ±0.04mm)
Card Guide
Paper
Paper
(3 / 4 sheets of 1P/55Kg paper)
Lightly insert the paper into a gap.
(between the card guide and the platen)
Pass : Paper = 3 sheets
(The paper passes through the edge
of opening of the card guide.)
Stop : Paper = 4 sheets
(The paper stops at the edge
of opening of the card guide.)